LIFTING BAR THAT WAS WARPED. WE PICKED IT UP FROM CUSTOMER AND REPAIRED IT. (THIS IS A PICTURE BEFORE REPAIR)
When two or more cranes are used to lift a load one qualified
responsible person shall be in charge of the operation. He shall analyze the
operation and instruct all personnel involved in the proper positioning,
rigging of the load, and the movements to be made.
WHEN NEEDING PARTS FOR YOUR OVERHEAD CRANE FINDING THE BRIDGE S/N AND THE HOIST S/N FROM THE CRANE CAN BE VERY HELPFUL TO THE PERSON LOCATING THE PARTS.
here is a link to a page that has great detail on how to measure a wire rope and how to convert english units to metric if needed. http://www.macwhyte.com/Resource_/TechnicalReference/784/How-to-measure-wire-rope-diameter.pdf
Other ropes. All rope which has been idle for a period of a month or
more due to shutdown or storage of a crane on which it is installed shall be
given a thorough inspection before it is used. This inspection shall be for all
types of deterioration and shall be performed by an appointed person whose
approval shall be required for further use of the rope. A certification record
shall be available for inspection which includes the date of inspection, the
signature of the person who performed the inspection and an identifier for the
rope which was inspected.
According to a study published by the National Institute for
Occupational Safety and Health of the Center for Disease Control and
Prevention, the Center for Construction Research and Training reports that side
pulling is one of the 13 most common ways people are killed or injured while
using cranes. But what is side pulling and why is it so dangerous?
OSHA defines side pull as “the hoist pull acting
horizontally when the hoist lines are not operated vertically” in their report
on overhead and gantry cranes, In other words,
the crane is used to “tow” a load that is not lined up properly to get it into
position. Side pulling purposely is extremely dangerous unless the crane is
stable and the load is small. In the vast majority of cases, side pulls should
not be used, even if the process could save some time. Using a crane to move
even a small load horizontally can be fatal. If you are going to operate a
crane while on the job, it is important to understand how to use one properly,
and if you are an employer who owns cranes, it is crucial that you provide on
the job training for your employees, not just to teach about side pull, but
also to help them understand all aspects of crane safety.
YOU CAN READ THE FULL ARTICLE HERE http://www.anapolschwartz.com/practices/construction-accidents/crane-accidents/side-pull-problems.asp
Lincoln Adams you can contact me at 859-431-2367